selective resample

[arteom]

I like your idea of setting which output channel gets resampled.

[arteom]

would like to be able to resample a single pad instead of all. This would be useful in making songs. Say you have all your samples recorded, an arrangement...

[arteom]

not only up and down but also left and right. would especially be useful for fine adjustments with step mode off....

[arteom]

Set some hard rules for yourself. No more than 3-4 tracks going at a time, or something like that....

[arteom]

Cool, take care.

[arteom]

I just tested and got the same results as you, following what you did in the video. Try doing what I outlined in my comment above. Start the clips first...

[arteom]

I feel like it's just doing what your telling it do. I can check on my blackbox, but I won't be able to until tomorrow. My workflow is slightly different...

[arteom]

You can have it playing. Just don't have it selected while a device might be sending the blackbox data! So start your clips, then move to another pad....

[arteom]

Sounds like your recorded clips are playing because the pad which they are occupying is selected in the pads section. To stop this from happening you...

[arteom]

actually that is not what I had in mind, though that in itself would be pretty cool. I will give you an example of what I was thinking, let's say you...

[arteom]

You can do this already. You just need to use a burner pad. Do this - load a sample to pad 1, set play mode to gate. Then mute it. Then go to a sequence,...

[arteom]

I know modulation has been brought up before, but from what I've read it's been ADSR or an LFO as a modulation source. What I would like to see is step...